15
DEHUMIDIFIER INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
Selecting a location
INSTALLATION
LOCATION CONSIDERATIONS
This unit is not to be accessible to the general public. The dehumidifiers should
be spaced evenly throughout the area to be dehumidified with the following
recommendations:
1. Avoid placement where the discharge of one dehumidifier is pointing
toward the inlet of another.
2. Avoid locating the dehumidifier inlet too near a supply register. Space is
not usually available to totally avoid this, but minimizing the amount of
cold air that is discharged to the dehumidifier inlet will improve moisture
removal performance of the dehumidifier.
3. Account for handling dehumidifier condensate by considering drain or
condensate pump locations.
4. Leave 18" (457 mm) minimum clearance on all sides for airflow and to
allow for access to the user interface, electrical panel for service and filter
for maintenance. Leave 20" (508 mm) for filter access (either side) on the
Model RL-6.
90-2530
FIGURE 15-1: SPACE CLEARANCES
(ALL MODELS)
Electrical
service panel
18"
(457mm)
minimum
18" (457mm)
recommended
Inlet side
Model RL-31
shown
To Next Page
Loading...
