Druck PACE - Maintenance

Copyright 2010 Baker Hughes Company.
English–PACE Calibration Manual | 1
Introduction
This technical manual gives calibration instructions for the PACE Pressure Controllers and
Indicators.
The features shown and described in this manual will not be available on some models.
For the full specification and user manual, refer to the Druck website:
https://druck.com
Safety
The manufacturer has designed this equipment to be safe when operated using the procedures
detailed in this manual. Do not use this equipment for any other purpose than shown, or it is
possible that the protection given by the equipment will not work.
This publication contains operating and safety instructions that must be followed to make sure of
sa
fe operation and to maintain the equipment in a safe condition. The safety instructions are
either warnings or cautions issued to protect the user and the equipment from injury or damage.
This manual has user instructions and safety information for the PACE instruments. All personnel
mu
st be correctly trained and qualified before they use or do maintenance on the instruments.
The customer must make sure this occurs.
Pressure
It is the responsibility of the calibration technician to apply pressures within the published
pressure range and to only use external pressure equipment with correctly rated fittings and
components.
Maintenance
This manual does not include maintenance details for the equipment. Refer to the separate User
Manuals for maintenance details. See “Associated Publications” on page 3.
WARNING Turn off the source pressure(s) and carefully release pressure
from the pressure lines before disconnecting or connecting the pressure lines.
Proceed with care.
Only use equipment with the correct pressure rating.
Before applying pressure, examine all fittings and equipment for damage.
Re
place all fittings and equipment that have damage. Do not use any fittings and
equipment that have damage. Do not apply more than the maximum working
pressure of the instrument.
This equipment is not rated for oxygen use.
Do not use with media that has an oxygen concentration > 21 % or other strong
ox
idizing agents.
This product contains materials or fluids that may degrade or combust in the
pr
esence of strong oxidizing agents.
Do not apply pressure greater than the maximum safe working pressure.