Druck PACE - Pressure Connection

Copyright 2010 Baker Hughes Company.
6 | PACE Calibration Manual–English
Refer to Table 1 and the Datasheet for more information.
5.1.2 Pressure Connection
The PACE has parallel thread pressure connectors. Use only the connector type shown in
Table 2.
Table 1: Pressure Adapters and other Parts
Part Details
IO-DIFF-KIT-LP Differential connection kit low pressure
IO-SNUBBER-1 Restricter/Snubber
IO-DIFFUSER-1 Diffuser
IO-ADAPT-1/4NPT ISO 228 G1/8 Male to 1/4 NPT Female.
IO-ADAPT-1/8NPT ISO 228 G1/8 Male to 1/8 NPT Female.
IO-ADAPT-7/16UNF ISO 228 G1/8 Male to 7/16-20 UNF Female.
IO-ADAPT-AN4 ISO 228 G1/8 Male to AN4 37° Male.
IO-ADAPT-AN6 ISO 228 G1/8 Male to AN6 37° Male.
IO-ADAPT-BARB ISO 228 G1/8 Male to 1/4 Hose.
IO-ADAPT-G1/4 ISO 228 G1/8 Male to ISO 228 G1/4 Female.
WARNING Parallel threads must be used. Female thread type is parallel
thread to ISO228/1 (DIN ISO228/1, JIS B0202) G1/8.
DO NOT CONNECT TAPERED THREADS DIRECTLY TO THE INDICATOR.
Connect NPT tapered threads through a suitable pressure adapter.
Table 2: PACE Pressure Connector Thread Specification
PACE Connector Thread Specification
Supply +, Supply -,
Output, Vent,
Reference
ISO228/1 G1/8 Parallel Threads (DIN ISO228/1, JIS
B0202)