EasyManuals Logo

DSC HS2016 User Guide

DSC HS2016
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Chapter12.0 Regulatory Agency Statements
12.0 Regulatory Agency
Statements
FCCCOMPLIANCESTATEMENT
CAUTION: Changesor modificationsnotexpresslyapproved byDigitalSecurity
Controlscouldvoid yourauthorityto use thisequipment.
Thisequipmenthasbeentestedand foundtocomply with thelimitsfor a ClassB
digital device,pursuant toPart 15ofthe FCC Rules.These limitsaredesigned to
provide reasonableprotectionagainst harmful interference inaresidential install-
ation.Thisequipmentgenerates,usesand canradiateradio frequency energyand,
ifnotinstalled and usedinaccordance with theinstructions,maycause harmful
interference toradiocommunications.However, there isno guarantee that inter-
ference willnotoccur inaparticular installation.If thisequipmentdoescause
harmful interferencetoradio ortelevisionreception, whichcanbe deter-minedby
turning theequipmentoff andon, theuserisencouragedto try tocorrectthe inter-
ference byone ormoreof the followingmeasures:
-Re-orientthe receiving antenna.
-Increasethe separation between theequipmentand receiver.
-Connectthe equipment into anoutleton acircuitdifferent from thattowhich
the receiverisconnected.
-Consultthe dealer orexperiencedradio/television technician forhelp.
The usermay find thefollowingbooklet prepared bytheFCCuseful:How to
Identify andResolveRadio/Television Interference Problems.Thisbookletis
available fromtheU.S.GovernmentPrintingOffice,Washington D.C.20402,Stock
#004-000-00345-4.
The keypadsrepresentedin thismanualcan beusedwith thefollowingControl
Units: HS2016,HS2032,HS2064,HS2128.
IMPORTANTINFORMATION
Thisequipmentcomplieswith Part68 oftheFCCRulesand, iftheproduct was
approvedJuly23,2001 orlater, therequirementsadopted bytheACTA.Onthe
side ofthisequipment is alabelthat contains,among other information,a product
identifier.If requested,thisnumbermust be providedtothe Telephone Company.
HS2016ProductIdentifier US:F53AL01BHS2128
HS2032ProductIdentifier US:F53AL01BHS2128
HS2064ProductIdentifier US:F53AL01BHS2128
HS2128ProductIdentifier US:F53AL01BHS2128
USOC Jack:RJ-31X
Telephone ConnectionRequirements
Aplugand jackusedto connect thisequipmentto thepremiseswiring andtele-
phonenetworkmust comply withtheapplicable FCC Part68 rulesandrequire-
mentsadoptedby the ACTA.Acomplianttelephone cord andmodularplug is
provided withthisproduct.It isdesignedto beconnectedto acompatiblemodular
jack thatisalsocompliant. See installation instructionsfordetails.
RingerEquivalenceNumber (REN)
The RENisusedtodetermine the numberofdevicesthatmaybe connectedtoa
telephone line.Excessive RENs onatelephone line mayresultin thedevicesnot
ringing inresponseto anincomingcall.In most butnotall areas,the sumofRENs
should notexceedfive (5.0). Tobecertain ofthenumber ofdevicesthat may be
connected toaline,asdeterminedbythe total RENs, contact thelocalTelephone
Company.Forproductsapproved after July23,2001,the RENforthisproductis
part ofthe product identifier that hasthe format US: AAAEQ##TXXXX. The digits
represented by##are theRENwithout adecimalpoint (e.g.,03 isaRENof0.3).
For earlierproducts,theRENisseparatelyshown onthelabel.
IncidenceofHarm
Ifthisequipment (HS2016,HS2032,HS2064,HS2128) causesharmto the telephone
network,the telephone companywillnotify youinadvance that temporary dis-
continuance ofservicemay berequired. Butifadvance notice isnotpractical,the
Telephone Companywillnotify the customerassoon aspossible. Also,youwillbe
advisedofyour righttofile a complaint withtheFCCifyou believe itisneces-
sary.
ChangesinTelephoneCompanyEquipment
orFacilities
The TelephoneCompanymay make changesinitsfacilities, equipment,oper-
ationsorproceduresthatcouldaffect the operationofthe equipment.If thishap-
pens theTelephoneCompany will provide advancenoticein orderforyou to
make necessarymodificationsto maintain uninterrupted service.
EquipmentMaintenanceFacility
Iftroubleisexperiencedwiththisequipment(HS2016, HS2032, HS2064,HS2128)
forrepairor warrantyinformation, contact thefacilityindicatedbelow.If-the
equipment iscausingharm tothetelephone network,the Telephone Company
may requestthatyou disconnecttheequipment until the problemissolved.This
equipment isofa typethatisnotintendedto berepairedby theenduser.
DSCc/oAPL Logistics757DouglasHillRd,LithiaSprings,GA 30122
AdditionalInformation
Connection topartyline service issubject to state tariffs.Contact the statepublic
utility commission,public service commission orcorporationcommission for
information.
Alarmdialingequipmentmust beableto seizethetelephone line and placea
call inanemergency situation.It must beableto dothiseven ifotherequipment
(telephone,answering system,computer modem,etc.)already hasthetelephone
line inuse.Todo so,alarmdialingequipmentmust beconnectedto aproperly
installed RJ-31Xjackthat iselectrically inserieswith andaheadof allother
equipment attached tothesame telephone line.Proper installation isdepictedin
the figurebelow.Ifyou haveanyquestionsconcerningtheseinstructions,you
should consultyourtelephone company ora qualified installer about installingthe
RJ-31Xjackand alarm dialing equipmentforyou.
INDUSTRYCANADASTATEMENT
NOTICE: Themodels:HS2016,HS2032,HS2064,HS2128 meet theapplicable
IndustryCanadaTerminal Equipment Technical Specifications.Thisisconfirmed
bytheregistration number.The abbreviation,IC,before theregistrationnumber
signifiesthatregistrationwasperformedbased onaDeclaration ofConformity
indicating that IndustryCanada technical specificationswere met. It doesnot
imply thatIndustryCanada approvedtheequipment.
NOTICE: TheRingerEquivalence Number (REN) forthisterminal equipment is
0.1. TheRENassigned toeachterminal equipment providesanindicationof the
maximum numberofterminalsallowedtobe connected toatelephone interface.
The termination onan interface may consistofany combination ofdevicessub-
ject onlytothe requirement thatthesum oftheRinger Equivalence Numbersof
all devicesdoesnot exceed5.
HS2016Registrationnumber IC:160A-HS2128
HS2032Registrationnumber IC:160A-HS2128
HS2064Registrationnumber IC:160A-HS2128
HS2128Registrationnumber IC:160A-HS2128
Thisproductisinconformitywith EMCDirective2004/108/EC basedonresults
using harmonizedstandardsin accordance witharticle10(5),R&TTE Directive
1999/5/EC basedon following AnnexIIIof thedirectiveand LVD Directive
2006/95/EC basedon resultsusingharmonizedstandards.
Thisproductmeetstherequirementsof Class II, Grade 2equipmentasperEN
50131-1:2006+A1:2009 Standard.Thisproductissuitable foruse in systemswith
the followingnotificationoptions:
-A(use oftwowarningdevicesand internal dialerrequired),
-B(self poweredwarning device andinternaldialer required),
-C(internal dialer andalternateIP/3Gcommunicator required)
-D(use ofalternateIP/GSMcommunicatorwithencryption enabled required).
The ModelHS2016,HS2032,HS2064,HS2128
Control Panelhasbeen certifiedbyTelefication according to EN50131-1:2006+
A1:2009,EN50131-3:2009,EN50131-6:2008 andEN50136-1:1997for Grade2,Class
II,ATS2.
FCCANDINDUSTRYCANADA
STATEMENTSFORWIRELESSKEYPADS
Models: HS2LCDRF9,HS2LCDRFP9,HS2ICNRF9,HS2ICNRFP9(operatingin912-
919MHz band)are compliant with applicable FCC Part15.247andIC RSS-210
rules.
WARNING!TocomplywithFCCandICRFexposurecompliancerequire-
ments,theHS2LCDRF(P)9orHS2ICNRF(P)9keypadsshouldbelocatedata
distanceofatleast20cmfromallpersonsduring
normal operation.The antennasusedfor thisproductmust notbeco-located or
operated inconjunctionwith anyotherantenna ortransmitter.
Thisdevicecomplieswith FCCRulesPart 15andwith IndustryCanadalicense-
exempt RSSstandard(s).Operationissubjecttothe following twoconditions:(1)
Thisdevicemay not causeharmfulinterference,and (2)thisdevicemustaccept
anyinterferencethatmay bereceivedor that maycauseundesired operation.
IC:160A –HS2KRFP9
The termIC”before theradiocertificationnumber onlysignifiesthat Industry
Canada technical specifications weremet.
AVERTISSEMENT! Pourrépondre aux exigencesdeconformité
delaFCCetd’Industrie Canada sur leslimitesd'expositionaux radiofréquences
(RF), lespasnumériquesHS2LCDRF(P)9ou HS2ICNRF(P)9 doiventêtreinstallés
àunedistance minimale de 20cmde toutepersonnelorsdeleur fonctionnement
usuel.Cesderniersne doivent pasêtresitsaumêmeendroit,ni être enfonction
avec uneautreantenne ouunautre transmetteur.
Le presentappareilest conformeauxCNRd'IndustrieCanadaapplicablesaux
appareilsradioexemptsdelicence. L'exploitationest autorisee auxdeux con-
ditionssuivantes:
(1)l'appareil ne doitpasproduire debrouillage, et (2)l'utilisateurdel'appareil
doit acceptertoutbrouillage radioelectrique subi,meme si le brouillage estsus-
ceptible d'en compromettre lefonctionnement.
Le presentappareilest conformeauxCNRd'IndustrieCanadaapplicablesaux
appareilsradioexemptsdelicence. L'exploitationest autorisee auxdeux con-
ditionssuivantes:
(1)l'appareil ne doitpasproduire debrouillage, et (2)l'utilisateurdel'appareil
doit acceptertoutbrouillage radioelectrique subi,meme si le brouillage estsus-
ceptible d'en compromettre lefonctionnement.
GENERALWARNING
The followingisalistof warningsapplicablewhen thisequipmentisconnected to
the NewZealand Telecom Network.
- 32 -

Other manuals for DSC HS2016

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DSC HS2016 and is the answer not in the manual?

DSC HS2016 Specifications

General IconGeneral
Mounting TypeWall mount
Power Supply16.5VAC
Battery Backup12VDC
Operating Temperature32°F to 120°F (0°C to 49°C)
Dimensions267mm

Related product manuals