DSC HS2016 - Monitoring; Maintenance

Chapter 3.0 The PowerSeries Neo Security System
2. Press[04]orusethescrollkeystonavigatetoSystemTestand
press[*].Thesystemactivatesallkeypadsounders,bells/sirens
andkeypadLEDsfortwoseconds.
Press (*) for <>
System Test
3. TogobacktotheReadystatepress[*].

3.3 Monitoring
Thissystemiscapableoftransmittingalarms,troubles&emergencyinformationtoacentralsta-
tion.Ifyouinitiateanalarmbymistake,immediatelycallthecentralstationtopreventanunne-
cessaryresponse.

Note:ForCP-01systems,themonitoringfunctionmustbeenabledbytheinstallerbeforeit
becomesfunctional.Thereisacommunicatordelayof30secondsinthiscontrolpanel.Itcanbe
removed,oritcanbeincreasedupto45seconds,attheoptionoftheend-userbyconsultingwith
theinstaller.
3.4 Maintenance
Withnormaluse,thesystemrequiresminimummaintenance.Notethefollowingpoints:
l Donotwashthesecurityequipmentwithawetcloth.Lightdustingwithaslightly
moistenedclothshouldremovenormalaccumulationsofdust.
l Usethesystemtestdescribedin“TestingYourSystem”tocheckthebatterycondition.
Werecommend,however,thatthestandbybatteriesbereplacedevery3-5years.
l Forothersystemdevicessuchassmokedetectors,passiveinfrared,ultrasonicor
microwavemotiondetectorsorglassbreakdetectors,consultthemanufacturer’sliterature
fortestingandmaintenanceinstructions.












- 8 -