48
Alt. Comms FTC
Trouble
The alarm control panel can no longer communicate
with the central monitoring station. The trouble is
generated after the programmed failed communica-
tion attempts. If a later attempt to communicate is
successful, the trouble is cleared.
Alt. Comms
Remote Shut-
down
The alternate communicator has been disabled
by the central station.
Alt. Comms
Encrypt Disabled
Alt. Comms Gen-
eral TX TBL
One of the following conditions has occurred:
• Radio not responding
• Not connected to central station
•No service
• Unstable signal
Alt. Comms TBL
XX
An unidentified trouble has occurred, XX is the trou-
ble number. Please see the appropriate alternate com-
municator manual for details.
Alt. Comms Low
Signal XX
The received signal strength is low, XX is the signal
strength.
T-Link Network
Fault
A communication problem has occurred between the
T-Link and the network.
T-Link Receiver
Trouble
When the T-Link module cannot communicate with
the receiver on the TCP/IP network.
T-Link Communi-
cations Fault
When the T-Link module cannot communicate with
the PC4020 on the PC-Link connection.
Seismic Trouble When zone types of this kind have failed a seismic test
this trouble will be displayed (see section 11 - PGM
Output types).
Display Trouble Condition
To Next Page
Loading...
