DSC PowerSeries PC585

Programming Worksheets: 5.32 Walk Test (Installer)
37
[351] Miscellaneous Maintenance Reporting Codes
(Section 5.8 “Communicator – Reporting Codes” on pg. 18, & Appendix A)
I_______I_______I 1. Telephone Number 1 Failure to Communicate
I_______I_______I 2. Telephone Number 2 Failure to Communicate
I_______I_______I 3. Event Buffer is 75% Full Since Last Upload
I_______I_______I 4. DLS Lead IN
I_______I_______I 5. DLS Lead OUT
I_______I_______I 6. General Zone Trouble Alarm
I_______I_______I 7. General Zone Trouble Restore
I_______I_______I 8. For Future Use
[352] Test Transmission Reporting Codes
(Section 5.8 “Communicator – Reporting Codes” on pg. 18, & Appendix A)
I_______I_______I 1. Periodic Test Transmission I_______I_______I 3. GSM1000 Test Transmission Code*
I_______I_______I 2. System Test
*The GSM1000 Test Transmission Code must be programmed as “00” for the GSM1000 Test Transmission to be disabled.
[353] Wireless Maintenance Reporting Codes
(Section 5.8 “Communicator – Reporting Codes” on pg. 18, & Appendix A)
I_______I_______I 1. Wireless Device Low Battery Alarm I_______I_______I 2. Wireless Device Low Battery Restore
[354] User Walk Test Reporting Codes
(Section 5.8 “Communicator – Reporting Codes” on pg. 18, & Appendix A)
I_______I_______I 1. Walk Test Lead In I_______I_______I 2. Walk Test Lead Out
[360] Communicator Format Options
(Section 5.9 “Communicator – Reporting Formats” )
NOTE:The Third telephone number follows the format of the First telephone number.
Default
04
I_______I_______I 1st/3rd Telephone Number
04 I_______I_______I 2nd Telephone Number
01 For Future Use 04 SIA FSK 07 For Future Use
02 For Future Use 05 Pager 08 For Future Use
03 DTMF CONTACT ID 06 Residential Dial 12 Robofon
[361] Alarm/Restore Communicator Call Directions
(Section 5.5 “Communicator – Dialing” )
Default Option ON OFF
ON I_______I 1 1st Telephone Number Disabled
OFF I_______I 2 2nd Telephone Number Disabled
OFF
I_______I 3 1st Telephone Number (via GSM1000) Disabled
OFF
I_______I 4 2nd Telephone Number (via GSM1000) Disabled
OFF I_______I 5-8 For Future Use
[363] Tamper/Restore Communicator Call Directions
(Section 5.5 “Communicator – Dialing” )
Default Option ON OFF
ON
I________I 1 1st Telephone Number Disabled
OFF
I________I 2 2nd Telephone Number Disabled
OFF
I_______I 3 1st Telephone Number (via GSM1000) Disabled
OFF I_______I 4 2nd Telephone Number (via GSM1000) Disabled
OFF
I_______I 5-8 For Future Use