DSC PowerSeries PC585

38
[365] Opening/Closing Communicator Call Directions
(Section 5.5 “Communicator – Dialing” )
Default Option ON OFF
OFF
I________I 1 1st Telephone Number Disabled
OFF
I________I 2 2nd Telephone Number Disabled
OFF
I_______I 3 1st Telephone Number (via GSM1000) Disabled
OFF
I_______I 4 2nd Telephone Number (via GSM1000) Disabled
OFF I_______I 5-8 For Future Use
[367] System Maintenance Alarm/Restore Communicator Call Directions
(Section 5.5 “Communicator – Dialing” )
Default Option ON OFF
ON
I________I 1 1st Telephone Number Disabled
OFF
I________I 2 2nd Telephone Number Disabled
OFF
I_______I 3 1st Telephone Number (via GSM1000) Disabled
OFF
I_______I 4 2nd Telephone Number (via GSM1000) Disabled
OFF I_______I 5-8 For Future Use
[368] System Test Transmissions Communicator Call Directions
(Section 5.5 “Communicator – Dialing” )
Default Option ON OFF
ON
I________I 1 1st Telephone Number Disabled
OFF I________I 2 2nd Telephone Number Disabled
OFF
I_______I 3 1st Telephone Number (via GSM1000) Disabled
OFF
I_______I 4 2nd Telephone Number (via GSM1000) Disabled
OFF
I_______I 5-8 For Future Use
NOTE:The GSM1000 backup call directions will only back up
their respective telephone numbers.
[370] Communication Variables
Default
010 I_______I_______I_______I Swinger Shutdown (Alarms and Rest) (001-014 Transmissions, 000=disabled)
010 I_______I_______I_______I Swinger Shutdown (Tampers and Rest)(001-014 Transmissions, 000=disabled)
010
I_______I_______I_______I Swinger Shutdown (Maint and Rest) (001-014 Transmissions, 000=disabled)
000
I_______I_______I_______I Transmission Delay (001-255 seconds)
030 I_______I_______I_______I AC Failure Communication Delay (001-255 minutes)
003
I_______I_______I_______I TLM Trouble Delay (No. of checks required - valid entries 003 - 255)
030
I_______I_______I_______I Test Transmission Cycle (land line) (001-255 minutes/days)†
030 I_______I_______I_______I For Future Use
003
I_______I_______I_______I Zone Low Battery Transmission Delay (000-255 days)
†Depends on programming in section [702], option [3].
NOTE: To program [000] for immediate AC failure reporting.
[371] Test Transmission Time of Day (Section 5.14 “Test Transmission” )
NOTE: If the land line test transmission cycle is programmed in
minutes (section [702], option [3]), this section will not affect
the land line test transmission cycle.
Default
9999 I_______I_______I_______I_______I (Valid entries are 0000-2359, 9999 to disable)