Ducati PANIGALE - DQS Indicator

DQS indicator
The instrument panel displays DQS current level.
The level can be customised using the Riding Mode
function present in the SETTING MENU.
If DQS is in degraded operation mode, relevant
indication is displayed flashing.
If DQS system is disabled,  is displayed.
When in fault, the red "Err" message is displayed
instead of the level.
The DQS with up/down feature allows the rider to
 and  without using the clutch lever.
It includes a two-way microswitch - built in the lever
mechanism - that outputs a signal to the engine
control unit whenever the  is operated.
The system works in a  way when 
and 
Tips on how to best exploit the DQS function:
●
The Ducati Quick  takes the same  lever
operation as with vehicle not equipped with the
Ducati Quick 
Ducati Quick  is not designed for 
automatically.
●
For any  request  or
 the rider has to move the 
lever from its idle position in the desired
direction against the force of the spring through
a  over-travel, then keep the  lever in
this position until the  is completed.
Once the  has been completed, the
lever has to be fully released in order to allow
another  acted by Ducati Quick  If
the rider does not move the  lever up to end
stroke during a Ducati Quick  request, gears
may not be fully engaged.
●
Ducati Quick  provides no assistance for the
 if the rider uses the clutch lever: the
DQS
EBC
1
N
0
2
3
4
5
6
7
8
9
11
10
12
12:34
PM
DTC
DDA OFF
3
3
U/D
ABS 1
DWCRPM X 1000
km/h
TOT
120 °C
SPORT
Gear
1
km
260
Fig 53
102