Ducati PANIGALE - Restoring Motorcycle Operation Via the PIN Code

Restoring motorcycle operation via
the PIN code
In case of key acknowledgement system or key
malfunction, the instrument panel allows the user to
enter his/her own PIN code to temporarily restore
motorcycle operation.
if the Pin Code function is active, the instrument
panel displays  Pin” with four spaces allowing
the rider to enter digits of the Pin code to be entered:
“0” and “- - -".
Entering the code:
●
use UP and DOWN  to increase and
decrease by 1 the value from “0” to “9”;
●
press ENTER  to confirm the digit and
move on to the following digit;
●
repeat the procedure until entering all 4 digits.
Once the  digit is set, press ENTER and the
instrument panel behaviour will be as follows:
●
if there is a problem during the pin check, the
instrument panel displays “Error” for 2 seconds
and then passes to the standard screen.
●
if the pin code is not correct, the instrument
panel displays “Wrong” for 2 seconds and then
goes back to previous screen, to allow you to try
again.
●
if the pin code is correct, the instrument panel
shows "Correct" for 2 seconds, and then displays
the standard screen.

If this procedure is necessary in order to 
the motorcycle, contact an Authorised Ducati
Service Centre as soon as possible to fix the problem.
Fig 25
52