Turn indicators
The instrument panel manages the turn indicators in
manual or automatic mode according to the
of the “Turn indicators” function present within the
SETTING MENU (see “SETTING MENU - Turn
indicators”). The turn indicators are activated using
the corresponding position of (3, Fig 20).
Manual activating one of the two
turn indicators, the user can deactivate them using
(3, Fig 20).
Automatic the turn indicators switch
automatically the turn, as calculated based on
vehicle speed, lean angle and in general according to
the analysis of vehicle dynamic conditions.
If the turn indicator switch is again operated, while
turn indicator is still on, automatic feature
is re-initialised.
The automatic deactivation systems are assist
systems helping the rider control the turn indicators
in the most and easy way. Such systems
have been designed to work in most riding
manoeuvres, nonetheless the rider must pay
to the turn indicator operation (disabling
or enabling them by hand if needed).
Hazard function (4 turn indicators)
The Hazard function turns all four turn indicators on
at the same time to signal an emergency condition.
This function is activated by pressing
(8, Fig 20).
When the Hazard function is active, all four turn
indicators blink at the same time as well as the
warning lights on the instrument panel.
If the Hazard function was activated upon key-on,
the same function will remain active upon it
will be automatically disabled 120 minutes.
In it is not possible to activate the Hazard
function.
Note
If key is turned on while the "Hazard" function
is active, the function remains active.
Note
If there is a sudden interruption in the
while the function is active, the instrument panel will
disable the function when the voltage is restored.
47
To Next Page
Loading...
