The side stand must be fully up (in a horizontal
position) as its safety sensor prevents engine
when down.
Note
It is possible to the engine with side stand
down and the gearbox in neutral. When the
motorcycle with a gear engaged, pull the clutch lever
(in this case the side stand must be up).
Keeping the engine running for too long with
the vehicle stationary can cause damage because of
overheating due to cooling. Do not keep
the engine on unnecessarily while the vehicle is
stationary. Move with the motorcycle
immediately the engine.
Make sure that emergency switch is set to
(A)
(RUN).
Press switch to the (B) and release it.
Let the motorcycle without operating the
control.
Note
If the is flat, system automatically
inhibits motor cranking operation.
Do not rev up the engine when it is cold. Allow
some time for oil to be heated and reach all points
that need lubricating.
Fig 37
64