116
Specifications
Model name DC-516
Product category Multi fi nisher Floor stand model
Infeed document size • Programmable document size
Width: 140−370 mm *1
Length: 150−1000 mm
(with HELP setting, length can be increased up to 1600 mm)
• Max Length of standard feed tray: 670 mm
(with optional LPT: 1000 mm)
• Max length of standard exit tray: 500 mm
(with optional LPT: 750 mm)
*1 when document width is 2 times longer than the document length
or more, the fi nishing tolerance may be effected.
Document type Uncoated, Coated, Laminated, UV coated
Document weight Creaser: 110−400 gsm
Cutter/Slitter: 110−350 gsm
Document curl No curl (Within 5 mm, no bent)
Process speed Creaser: 100 sheets/min (A4 SEF 1 center creaser)
Slitter/Cutter: 23 sheets/min (2up×A4 on SRA3)
11 sheets/min (3x7up business card on SRA3)
Tolerance ±0.2 on programmed position
(business card: ±0.3 mm)
* The tolerance may be effected by the infeed document length/
document surface conditions.
* The tolerance of creasing may be effected by the number of creases
on the sheet and their depths.
Feeding method Belt suction
Feed tray capacity 360 mm (With document longer than 460 mm: 100 mm)
JOB memory 250
Double feed detection Ultrasonic sensor
REG mark reading for
image shift compensation
Refl ective sensor
*With document with uneven/pearlescent surface, the sensor may not
work properly.
Slots for replaceable
modules
2
Modules can be used on
slot1
Standard module
Slitter module
Creaser module
Modules can be used on
slot2
Crease module
Cutter module
Number of slits 6 slits/sheet
(With optional slitter units installed, can be increased up to 10.)
Margin slit width 3.2−55 mm
Gutter slit width
5−15 mm
Number of creases Max. 20 creases/sheet with each module
To Next Page
Loading...
General