18
Preparation Before Use
IMPORTANT
REFERENCE
REFERENCE
The fi nished products are automatically ejected to the
card stacker
60 seconds later. You can also eject
them by pressing the STOP key or the TEST key.
When using light weight documents and not
setting gutter slits in programming a JOB, set the
speed to
SLOW
.
Pressing the START key ejects documents remained at the exit area and then starts
continuous processing of all the documents on the
feed tray
.
When the number of a preset is programmed, it processes as many sheets as the number
of the preset.
Insert the support
guide in this gap.
Support guide
Support guide
After attachment
When the fi nished document length is longer than the
guide, attach the support guides (for the card stacker)
to the guide.
When moving the
guide
after attaching the
support
guides
, hold the circled part as shown in the fi gure on
the right, not the
support guides
.
If you move the guide by holding the
support guides
,
they may bend.
● How to Use the Support Guide Adjustment (for Card Stacker)
To Next Page
Loading...
General