Programming a JOB
53
Programming JOB
2
-2%&XW6OLW
6(7
ڸ
ڸ
ڸ
ڸ
'RQH
● Cut Slit
1. Width
2. Length
3. Width of a fi nished product
4. Length of a fi nished product
5. Lead cut
6. Gutter cut between fi nished products
7. Right margin
8. Gutter slit between fi nished products
9. REG mark position
10. Number of cards in lengthwise
11. Number of cards in width wise
1RWHQRXJKVOLWWHUV5HYLHZWKH
FDUGURZVRUJXWWHUVOLWV
$
%
1RWHQRXJK6OLWWHU5&DQQRWSURFHVV
PDUJLQ5
1(;7
1RWHQRXJK6OLWWHU/&DQQRWSURFHVV
PDUJLQ/
1(;7
• Slitter error messages
1. When there are not enough slitters
The number of the slitter units used in the
programmed JOB is larger than that of ones
installed in the slitter module. Reset JOB the
setting.
2. When there are not enough slitter tools (right).
3. When there are not enough slitter tools (left).
REFERENCE
Touching the
return
icon returns to the
previous screen.
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
General