Duplo DC-516 - Page 73

Programming a JOB
55
Programming JOB
2
&KDQJHWKHQXPEHURIFDUGVLQ
ZLGWKZLVH
1(;7
10. When the number of the fi nished products in
widthwise exceeds the limit.
7KHILQLVKHGZLGWKLVRXWRIVSHF
&KDQJHWKHVOLWSRVLWLRQSURJUDP
9. When the width of the fi nished product exceeds
the specifi cations.
• Cutter error messages
1. When the total cut is 31 or more (out of
specifi cations).
7RWDOFXWH[FHHGVWKHVSHF5HGXFHWKH
URZVRUORVHJXWWHUFXWV
࣭࣭࣭
1(;7
1RFXWDOORZHGZLWKLQPPEHIRUHWKH
WUDLOHGJH&KDQJHWKHFXWSRVLWLRQ
Ӎ
1(;7
2. When a cut position is set within 5 mm from
the trail edge of the document.
REFERENCE