5.2 Fitting the keypad to the sewing-machine arm
The keypad 2 and guard 4 will be found in the special sewing machine’s accessory pack.
There are tapped holes on the operator’s side of the sewing-machine arm for the
attachment of the keypad 2.
–
Screw the keypad 2 with mounting bracket 4 onto the sewing-machine arm behind
the thread-tensioning plate 1.
–
Lay the connection cable 5 behind the guard 4 and screw the guard to the rear of
the sewing-machine arm.
–
Pass the connection cable 5 down through the cable-holder on the sewing-machine
pillar.
–
Pass the connection cable 5 down through hole 7 in the table plate.
–
Insert plug 6 of the connection-cable 5 into socket D of the control cabinet.
(See section 6.4)
5.3 Fitting the operating panel
–
Screw the operating panel 10 with bracket 9, screws and washers to the table
plate 8.
–
Pass the connection cable down through hole 7 in the table plate.
–
Insert the connection cable into the cable conduit beneath the table plate at the
side and pass it forwards.
–
Insert the connection-cable plug into socket
b776
of the control cabinet.
(See section 6.6)
GB
11
To Next Page
Loading...
