8. Lubrication
Caution - danger of injury!
Oil can cause skin eruptions.
Avoid protracted contact with the skin.
In the event of contact, thoroughly wash the affected area.
CAUTION!
The handling and disposal of mineral oils is subject to legal
regulation.
Deliver used oil to an authorised collection point.
Protect your environment.
Take care not to spill oil.
To top up the oil reservoir use only
ESSO SP-NK 10
lubricating oil
or an equivalent oil of the following specification:
–
viscosity at 40° C : 10 mm2/s
–
flashpoint: 150 °C
ESSO SP-NK 10
is available from
DÜRKOPP ADLER AG
retail outlets under the
following part numbers:
2-litre container: 9047 000013
5-litre container: 9047 000014
8.1 Topping up with oil
Lubricating the head and lower part of the sewing-machine
–
Top up with oil through the hole beneath stopper 1.
–
Check oil level at the sight glass 2.
The oil level must be above the red
"full"
line.
–
Screw stopper 1 (in the accessory pack) into the hole in the arm cover.
–
Remove any oil spillage from the oil collector.
Shuttle lubrication
–
Use the oil can (in the accessory pack) to drip a few drops of oil into hole 3 in the
shuttle plunger ring 4.
CAUTION!
In order to ensure that the shuttle is properly lubricated
during the running-in period, a relatively large quantity of
oil is set prior to despatch.
This setting should be checked, and after the running-in
period reduced to the required quantity (see servicing
instructions).
GB
33
To Next Page
Loading...
