10.2 Compressed-air maintenance unit
The WE-6 filter controller for pneumatic ancillary equipment is available under
order no. 9781 000002.
Connecting the compressed-air maintenance unit
–
Attach the compressed-air maintenance unit 4 with bracket 3 and link plate 2 to the
frame brace 1.
–
Connect the compressed-air maintenance unit to the works compressed-air supply
with connection hose 5 (Ø = 9 mm) and R1/4" hose connector.
Adjusting the operating pressure
The operating pressure is
6 bar
.
It can be read off at the manometer 7.
–
To adjust the operating pressure pull out and rotate the handle 6:
clockwise = to increase pressure
anti- clockwise = to decrease pressure.
10.3 Tape guide
Fitting the tape-roll holders
–
Attach the holder 1 with 4 screws beneath the table plate. Care must be taken that
the centre of the tape on the tape-roll holder coincides with the centre of the seam.
1
GB
41
To Next Page
Loading...
