DURKOPP ADLER 768 - Changing Parameter Values; Direct Parameter-Number Selection

6.10.2.2 Setting Positions with the V810 Control Panel
Entry of the code number for the technician level
–
Turn the main switch off.
–
All plugs on the controls of the sewing drive must be plugged in.
–
Press the "
P
" key and hold pressed.
–
Turn the main switch on. The display shows "
C-0000
"
–
Release the "
P
" key
–
Enter code no.
1907
. With the "
+
" and "
-
" keys, the value of the blinking number is
changed. The next number is called up with the ">>>>" key.
–
Press the "
E
" key. The first parameter,
F-100
, at the technician level is shown.
Setting the reference position
–
After entry of the code number press the "
E
" key.
The first parameter,
F-100
, at the technician level is shown.
–
With the "
+
", "
-
" and ">>>>" keys set the parameter
F-170
.
–
Press the "
E
" key. Shown in the display = "
Sr1
"
–
Press the "
>>
" key. Shown in the display = "
PoS0 ( )
"
–
Turn the handwheel in the normal direction of turn until the character "
( )
"
disappears from the display, then turn farther until the reference position (needle
point, with lowered needle, at the level of the top of the needle plate) is reached.
–
Press the "
E
" key. The reference position is saved. Shown in the display "
F- 171
"
–
If the reference position was not saved, an error message appears in the display =
"
inF E3
". Turn the handwheel farther, press the "
E
" key and repeat the procedure
above.
Setting positions 1 and 2
–
The reference position is set. (see above)
–
Enter parameter
F-171
.
–
Press the "
E
" key. Shown in the display = "
Sr2
"
–
Press the "
>>
" key. Shown in the display = "
1 xxx"
= parameter value of pos. 1.
–
If necessary, correct parameter value *. Either with the "
+
" and "
-
" keys or by
turning the handwheel.
–
Press the "
E
" key. Shown in the display = "
2 xxx
" = parameter value of pos. 2
–
If necessary, correct parameter value *. Either with the "
+
" and "
-
" keys or by
turning the handwheel.
–
Press the "
E
" key. Shown in the display = "
1A xxx
" = parameter value of pos. 1A
–
If necessary, correct parameter value *. Either with the "
+
" and "
-
" keys or by
turning the handwheel.
–
Press the "
E
" key. Shown in the display = "
2A xxx
" = parameter value of pos. 2A
–
If necessary, correct parameter value *. Either with the "
+
" and "
-
" keys or by
turning the handwheel.
–
Press the "
P
" key twice. The settings are completed, the programming level is
exited
–
Check the positions. See Chapter 6.10.2.4
* Attention!
The parameter values for the positions 1, 2, 1A and 2A are to be found on
the parameter sheet (accessories pack).
GB
23