Fitting the sewing-light transformer
Power for the sewing lamps is supplied by the sewing-light transformer which is
available as ancillary equipment (order no. 0798 500088).
–
Attach the sewing-light transformer 2 beneath the table plate with chipboard
screws 1.
–
Attach the connection cable beneath the table plate with cable ties.
Connecting the sewing lamp
CAUTION!
Turning off the main switch does not turn off the power
supply to the sewing lamp.
–
Stick the adhesive label 3 with safety warning to the front of the main switch.
–
Pass the sewing-lamp connection cable behind the guard on the sewing-machine
arm.
–
Pass the connection cable down through the cable-holders on the pillar.
–
Pass the connection cable down through hole 4 in the table plate.
–
Plug the cable into the sewing-light transformer.
GB
39
To Next Page
Loading...
