DURKOPP ADLER 806 - 6 Refilling the Oil; Head No. 806-121

6. Refilling the oil
The oil reservoir should be filled only with
ESSO SP-NK 10
or an
equivalent oil of the following specification:
–
viscosity at 40°C : 10 mm2/s
–
flashpoint: 150 °C
ESSO SP-NK 10
can be obtained from DÜRKOPP ADLER AG sales
outlets.
Caution: danger of injury
Oil can cause skin rashes.
Avoid protracted contact with the skin.
Wash thoroughly after contact.
IMPORTANT
The handling and disposal of mineral oils are governed by legal
provisions.
Take used oil to an authorised acceptance point.
Protect the environment.
Take care not to spill any oil.
6.1 Head subclass 806-121
–
Check the oil level at container 1.
The oil level must be between the MIN and MAX marks.
–
If the oil level in container 1 has reached the MIN mark, the oil
level in container 2 should also be checked.
If the oil level there is above the MAX mark, do not add any oil.
Complete a further 20 or so sewing cycles and check the oil level
again.
–
Add oil through the oil-filler neck of container 1.
–
Remove spilt oil from the oil sump.
1
2
12