DURKOPP ADLER 806 - 3 Covers; Removing the Covers above the Table; Removing the Covers below the Table

3. Covers
3.1 Removing the covers above the table
Make absolutely sure to remove the covers above the table in the
order described below.
Cover 6 sewing head
–
Loosen the clamping on the reel stand.
–
Pull the reel stand up and out.
–
Move the cover to the right and lift it off.
Cover 5 carriage
–
Remove the cover by lifting it off.
Cover 1 folding station
–
Loosen the fixture of the control.
–
Pull the control up and remove it.
–
Pull the cover up and remove it.
At the same time pay attention to the control-panel guide.
3.2 Removing the covers below the table
Cover 10 on the left at the back and cover 11 on the right at the
back
–
Pull the covers up and remove them towards the front.
Covers 4 on the left at the front and Cover 7 on the right at the
front
–
Pull the covers up and remove them towards the front.
Cover 2 left-hand side
–
Dismantle the stacker plates.
–
Pull the covers up and remove them towards the front.
Cover 9 right-hand side
–
Pull the covers up and remove them towards the front.
Cover 8 Stacker
–
Swing the stacker plate towards the machine.
–
Loosen all 7 fixing screws.
–
Pull the cover off towards the front.
7