DURKOPP ADLER 806 - Introduction and General Safety Instructions; Product Description; Operating the Unit

2. Installing the sewing unit
CAUTION
The sewing unit may only be installed by skilled personnel.
2.1 Transport safety devices
The following units are secured by means of transport safety devices:
–
Sewing head
–
Stacker
–
Transfer carriage
–
Folding device
Removing the transport safety devices
–
Remove the covers above the table according to section 3.1.
–
Loosen the screws 2 of the transport safety device on the sewing
head.
–
Remove the transport safety device 3.
–
Remove the holding straps on the stacker.
–
Tilt the stacker forward.
–
Remove the holding straps on the transfer carriage.
–
Remove the holding straps on the cylinder 1 of the folding device.
–
Remove the wooden block on the cylinder 1.
–
Mount the covers above the table according to section 3.3.
1
2
3
4