LabelWriter Twin Turbo Printer
Input current (idle) 0.026 Amps
Input current (typical) 0.975 Amps (text only)
Input current (max.) 3.3 Amps based on printing a shipping label (30256) with a
maximum-size filled rectangle, after print head temperature
increases above ambient temperature.
At nominal print head temperature: 2.9 A
In graphics mode: 1.6 A
LabelWriter Duo Printer
Input current (idle) 0.052 Amps
Input current (typical) 1.1 Amps (text only)
Input current (max.) 3.3 Amps based on printing a shipping label (30256) with a
maximum-size filled rectangle, after print head temperature
increases above ambient temperature.
At nominal print head temperature: 3.0 A
Note: The input current is ramped up as the 24 V is applied to the input to limit in-rush
current (there is a 2200µF filter capacitor at the input). After power is removed, allow
seven seconds for this circuit to reset before re-applying the input voltage.
Connector (JP2)
DC jack, 5.5 mm O.D. x 2.5 mm I.D. Center Positive
Copyright © 2006, DYMO Corporation Page 13
To Next Page
Loading...
