DSP 600
23
FROM THE FRONT PANEL
Press the Setup button and use the <SELECT> buttons to navigate to the Lock menu.
Locking the DSP 600
Use the < SELECT > buttons to navigate to the Mode parameter. Use the VALUE up/down buttons to choose the required
protection mode. Use the < SELECT > buttons to navigate to the Code parameter. Use the VALUE up/down buttons to
choose your four digit code. Press the Store button to lock the DSP 600.
Unlocking the DSP 600
When the DSP 600 is locked the Mode parameter indicates the currently used protection mode. Use the < SELECT >
buttons to navigate to the Code parameter. Use the VALUE up/down buttons to enter the four digit code. Press the Store
button to unlock the DSP 600.
F
ROM IRIS-NET
Open the DSP 600 Configuration Panel in IRIS-Net. Select the Front Panel Access tab. Any or all of the DSP 600’s DSP
blocks and/or individual parameters within the DSP blocks can be locked from this window by selecting the correspond-
ing box to engage the lock icon or hidden by selecting the corresponding box to engage the eye icon. For example, an
installer may chose to lock and hide all Limiter parameters, lock all Crossover parameters but leave them visible, and
lock the last 5 Input PEQ filters, leaving the first 5 available for the user to edit and modify.
To Next Page
Loading...
Need help?
General