19CA 602 O602EN1
STARTING
Starting the engine
Fig. 17 Control panel
39. Forward/reverse lever
Fig. 18 Instrument panel
1. Starter switch
10. Voltmeter (Optional)
23. Revs control
24. Amplitude selector
27. Brake lamp
28. Oil pressure lamp
31. Charging lamp
10
1 31 28 27 24 23
39
Set the forward/reverse lever (39) in neutral. The
engine can only be started with the lever in neutral.
Set the amplitude selector (24) for Low/High vibration to
mode O.
Set the revs control (23) to the idling mode.
Turn the starter switch (1) right to the starting mode,
release the knob as soon as the engine fires.
Do not run the starter motor too long. If the
engine does not start immediately, wait a
minute or so before making a new attempt.
Warm up the diesel engine with the engine speed
control at the idling setting for a few minutes, or for a
longer period if the ambient air temperature is below
+10°C (+50°F).
Check while warming up that the warning lamps for oil
pressure (28) and charging (31) are out, and that the
voltmeter (10) shows 13–14 volt. The warning lamp
(27) for the parking brake shall still light.
When starting up and driving a cold machi-
ne, ie, cold hydraulic fluid, the braking
distance will be longer than normal until
the fluid reaches normal working tempera-
ture.
Ensure that ventilation (evacuation) is
adequate if the engine is run indoors. ie,
danger of carbon monoxide poisoning.
WARNING
WARNING
CAUTION
To Next Page
Loading...
