Dynapac LP8500 - Manual pre-start checks and engine start

22
LP8500 ILP8500EN1
1. Take out the transmitter and store in a safe place.
2. Open the rear service cover. Move cable from upper
to lower contact (1).
3. Remove the protective cover (2) from manual
buttons. Attach with screw (3) (see picture).
Check so the buttons are in non-active mode.
4. Pull out the Emergency Stop Button (4). Insert and
turn the battery disconnector (5) to locked mode.
The beeper sounds when power is switched on. The
beeper stops as the engine starts.
5. Press the start button (6).
6. Close the rear service cover.
CHECKS BEFORE STARTING
Observe the safety regulations. Ensure that "Daily"
Maintenance has been carried out, see schedule.
- Check engine oil level.
- Check hydraulic oil level.
- Check fuel level.
- Check scraper adjustment.
- Check function emergency brake.
- Visually inspect the machine for hydraulic leaks and
loose bolts.
Starting the engine, manual
controls
1
2
3
OPERATION – TEMPORARY OPERATED
L000626A
L000627A
L000625B
4
6
5
Before operation check funktion of the
push stop. Move the push stop forward
when the machine drives backward.
The machine must stop immediately when
the push stop is activated.
Never go beside the machine during
operation.
WARNING
WARNING