23
LP8500 ILP8500EN1
Operating, manual controls.
Warning! Be sure that your working area is safe. Wet and loose soils reduce the
traction abilities of the machine, especially on grades. Always travel slowly on a
grade and over rough terrain.
Never drive up or down inclinations which exceed the gradability of the machine.
- Don't leave the machine with the engine running.
- Don't allow any passenger on the machine.
Vibration
Caution! Never use vibration on hard surfaces such as frozen ground or concrete.
Use vibration only when machine is moving.
The Vibration Switch functions only when the Speed Switch is set to "Low",
it will not operate in "High".
The switch has 3 positions; ON Forward, OFF, and ON Reverse. This allows the
operator to select the direction of rotation of the eccentric shaft to improve traction.
OPERATION – TEMPORARY OPERATED
Stopping the engine, manual controls.
1. Turn off vibration. Set the speed switches (lower left + middle) to low mode.
2. Open the rear service cover and press the stop button (Same as start). Turn off the
battery disconnector.
3. Press down the emergency stop button.
4. Close the rear service cover and reattach the protective cover over the buttons.
WARNING
CAUTION
To Next Page
Loading...
