Dynascan DS751LT4 - Operating Instructions; Powering On;Off the Display; Using the Remote Control

DS751LT4 User Manual 16
Operating Instructions
Powering On/Off the Display
To turn on/off the display, press the power switch on the back of the display as shown in the diagram
below.
Using the Remote Control
When using the remote control, aim the remote at the IR receiver on the display. The IR receiver on
the DS751LT4 model is at the rear of the display with a receiving angle of 100 degrees. The IR
receiver configurations of the model are shown in the figure below.
The operating range of the remote control is 2.5 meters (8 feet).
Ambient light may affect the performance of the remote control. Avoid fluorescent or neon lights in the
vicinity.
NOTE: The remote control only works
when the power switch is ON.
OFF
ON