Dynatron® 850plus & 550plus
IFC & PREMOD - Treatment Instructions
28
• Use the High/Low toggle key to select a different frequency option (High, Low,
or High/Low alternating only. High/Low consecutive is only available during
treatment setup).
• Use the Target/Sweep toggle key to change this option (IFC only)
• Use the Time arrow keys to increase or decrease the treatment time.
• Use the Intensity arrow keys to increase or decrease the intensity.
• Relocate the treatment site by touching the Target pad at any time during the
treatment (only when Target is selected).
9. Press STOP if it is necessary to stop a treatment before time has expired.
When the treatment time has elapsed, the current to the patient stops and a tone sounds
notifying you of the treatment end. Treatments in progress may be stopped at any time
using one of the following methods.
STOP: Press this key to stop all treatments at all channels.
REMOTE STOP: During “unattended therapy,” a patient stop button is provided to
allow the patient to stop treatment. The remote cord should be plugged into the machine
prior to starting the treatment. When the remote stop button is pressed, all output from
the device is stopped, time is set to zero, and a tone sounds briefly.
STOP ONE TREATMENT ONLY: If you have more than one treatment in progress,
you can stop one treatment by either of the following methods. First, press the channel
toggle key to select the channel to be stopped (that channel’s light is green when
selected).
FUNCTION-STOP. Press and hold the FUNCTION key and press STOP.
REDUCE THE TREATMENT TIME TO ZERO. Press the Time down arrow
until the Time display reaches zero. The device beeps when the time reaches
zero.
The output at the selected channel is stopped, and the device then displays the parameters
for the next treatment that remains in progress (if any).
Interferential / Premodulated Default Settings
The following default settings are set by the manufacturer and are selected when you select
IFC or PREMOD. You may change these defaults to your own preferred settings. See
“Setting Defaults” in this manual.
Interferential
• High frequency range
• Target
• Time: 10 minutes
Premodulated
• High frequency range
• Time: 10 minutes
To Next Page
Loading...
