Dynatron® 850plus & 550plus
Treatment Instructions - HIGH VOLT
41
High Volt Default Settings
The following default settings are set by the manufacturer and are selected when you select
High Volt. You may change these defaults to your own preferred settings. See “Setting
Defaults” in this manual.
• Continuous on cycle
• Treatment time: 10 minutes
• Ramp up and down time: .5 sec.
• Polarity: Negative
• Pulse Rate: High Range
Default High Range: 80-120 Hz
Default Low Range: 1-10 Hz
Available Range: 1-200 Hz
To Next Page
Loading...
