Dynaudio Sub 3 User Manual

13
Unpacking
Check that the contents are
complete
• Subwoofer: The factory-set power
requirements (refer to label on rear
of subwoofer) should correspond for
the region where the subwoofer was
purchased. Refer also to chapter
“Important Safety Instructions” on
page 8.
• Front bafe grille
• AC mains lead. The supplied
lead should be suitable for the
region where the subwoofer was
purchased.
• Owners manual
Grille
The subwoofer can be operated without
the grille. However, it is recommended
that the grille is mounted during
normal use to help prevent accidental
damage or dirt settling on the cone of
the loudspeaker. With subwoofers, the
inuence of the grille on the sound is
virtually negligible.
To remove the grille:
Gently pull the grille at all corners.
To t the grille:
Line up the studs with the
corresponding front bafe holes.
Gently push the grille in at all
corners.
Note
Be careful when mounting the
grille not to touch the cone of the
loudspeaker itself.
123

Dynaudio Sub 3 Specifications

General

On/off switch	Yes
Product color	Black
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Subwoofer type	Active subwoofer
Number of subwoofers	1
Subwoofer peak power	300 W
Subwoofer driver diameter	240 mm
Subwoofer frequency range	22 - 175 Hz
Subwoofer crossover frequencies	60 - 80 Hz
Line inputs (RCA)	3

Weight and Dimensions

Subwoofer depth	320 mm
Subwoofer width	266 mm
Subwoofer height	276 mm
Subwoofer weight	10500 g