Dynaudio Xeo 4 - Volume Control and Standby Modes; Fixing Speaker Volume Level; Speaker Sleep and Standby Modes

21Xeo 4 / Xeo 6
Fixing the volume
You can set the speaker to a higher volume using the function to x the volume. This setting also
remains in e󰀨ect in standby mode. If a signal source is connected to a Hub with its own volume
control, you have the option to change the output volume across a broad range with the signal source.
To x the volume:
► Point the remote control at the speaker and press
for at least 2 seconds. To undo xing, press
one of the two volume buttons.
Standby
To switch a speaker to sleep mode:
► Point the remote control at the speaker and press
or press .
▼ The speaker will go into sleep mode.
To completely switch o󰀨 the speaker, turn the POWER switch on the rear to OFF. However, the
speaker can then no longer be switched on via the remote control.
▼ The speakers also go to sleep mode if there is no audio signal for 20 minutes.
▼ In this mode the wireless network will be active and all connected units will remain
synchronized.
▼ Sleep mode power consumption is <2 W.
To switch a speaker to low power standby mode:
► Press and hold
on remote control for 5 seconds.
▼ The speakers go to low power standby mode.
▼ In this mode the wireless network is disabled and there is no connection between the speakers.
▼ Low-power standby mode power consumption is <0.5 W.
► To completely switch o󰀨 the speaker, turn the POWER switch on the rear to OFF.
▼ However, the speaker can then no longer be switched on via the remote control.