Dynaudio Xeo 4 - Connecting and Adjusting Speakers; Speaker Power-On Procedure; Selecting Audio Sources

20 Dynaudio
Connecting the power cable and adjusting
1. In stereo mode:
– Select Left operating mode for the left speaker.
– Select Right operating mode for the right speaker.
– Select Mono for mono operating mode.
2. Set the speaker position switch that best describes the speakers need for acoustic compensation.
– Neutral = with free-standing placement
– Wall = if placed near a wall
– Corner = if placed in a corner
3. Select the Red, Green, or Blue zone. In stereo, select the same zone for the right and left
speakers. Speakers with di󰀨erent zone settings can be controlled separately via the remote control
(see „Division into audio zones“ on page 26 for further information).
4. Use the power cable to connect the speaker to the mains voltage.
Power it on using the power switch on the rear.
Switching on
To switch the speaker on from standby mode:
► Press
on the interface display or press on the remote control.
▼ The speaker will automatically search for an active Hub and an audio signal. If found, the signal
will be output (autoplay function).
▼ If there is no input signal, the speaker will keep on scanning the inputs for the next 20 minutes
and go to sleep mode.
If there is no input signal, the speaker will go into standby mode after a certain period.
Selecting a Hub or input/autoplay function
After it is turned on, the speaker automatically searches for an audio signal and then plays it back
immediately. If several signal sources are active, one of the signal sources will be played back. Select
a di󰀨erent Hub or input if you want to play back a di󰀨erent signal source.
To select a di󰀨erent Hub or input:
► Press HUB A, B, or C or INPUT 1, 2, 3, or 4 on the remote control.
▼ The selected signal source will be played back.