Proteus 1000 Operation Manual 93
Edit Menu
Defining Layer Parameters
To Set Up a Velocity Crossfade Between Layers
Set the velocity fades so that layer 1 fades out with higher key velocity,
while layer 2 fades in. At a velocity of 64, the two sounds are equal volume.
You may want to adjust the fade in and fade out points to achieve a natural
sounding crossfade. These parameters vary depending on the sounds.
Increasing Velocity0
127
Layer 2Layer 1
Layer 2Layer 1
L1
VEL: LO FADE HIGH FADE
0
00 000 127 127
L2
VEL: LO FADE HIGH FADE
0
00 127 127 000
To Next Page
Loading...
Need help?
General
