To Next Page

To Previous Page

Proteus 1000 Operation Manual 27

Basic Operations

Main Screen

• Select banks independently of the of the preset number by locating the

cursor on the Bank ﬁeld and turning the Data Entry Control.

This chart shows the MSB and LSB numbers needed to select preset banks over MIDI.

Select a bank, then send the program change number. Without a bank select command,

presets are selected from within the current bank.

Channel Volume Channel Volume sets the volume of the selected MIDI channel in relation

to the other channels. This is the same parameter as MIDI volume control

#7, and changes made over MIDI are shown in the display.

 To Change the Channel Volume

1. Press either cursor key until the cursor is underneath the volume value.

2. Rotate the Data Entry Control to select a volume level. The Channel

Volume range is 000-127.

CMPSR

Bank 0

Bank 1

Bank 2

Bank 3

Bank 0

Bank 1

Bank 2

Bank 3

Bank 4

Bank 5

Bank 6

Bank 7

USER

MIDI BANK SELECT

cc00 cc32

MSB LSB

032

bas: Interference

Volume

C01 Vol127 Pan01

User

E-Mu proteus 2000 User Manual

Other manuals for E-Mu proteus 2000