e-survey ET2A - Set the Baud Rate; Check and Adjust the Line-of-Sight Error or Collimation Error

SHANGHAI ESURVEY GNSS CO., LTD.
31
7.5 Set the Baud Rate
To set the baud rate, do the following:
1. Press → R/L to enter configuration mode:
2. Press 0SET to turn to the following page:
3. Do one of the following:
o To set the baud rate to 1200, press R/L to change the value to 1200.
o To set the baud rate to 2400, press R/L to change the value to 2400.
o To set the baud rate to 4800, press R/L to change the value to 4800.
o To set the baud rate to 9600, press R/L to change the value to 9600.
4. Press to confirm selection.