EasyManua.ls Logo

E.T. Systems Drive 600 - Tamper Alarms; Beam Tamper in Closed Position; Gate Kept Open Too Long Alarm

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Advanced features
Tamper alarms.
Beam tamper in closed posion.
In cases where the safety beams have been tampered with, the safety protocols will sll allow the gates to open but will not allow the gates to close.
This safety feature can be turned into a security risk by anyone with ill intenon. The safety beam input tampering alarm feature gives you a ealry
warning of any tampering that may have occured while you were away from the property. If the gates are in the closed posion and the safety beam
input is trigger for longer than 20 seconds, then the alarm output will become acve. This output would usually be connected to a visual warning
device such as a light or to a zone on the household alarm system.
In the case of a light being used, on approach to the entrance the user is alerted to the aempt to compromise their security. Our advise is that the
user not trigger the gates to open, in this situaon, but rather to connue driving to their nearest armed response standby point or to the nearest
police staon. This way they can ask for an escort onto the property.
Safety beam alarm mode is available in all modes of operaon so long as a set of safety beams is installed.
Acon Response
Safety beam equipment
tampered with while
gates are in the closed
posion.
Alarm output
remains in
standby status.
20 seconds aer safety
beam equipment has
been tampered with.
Alarm output
acvates.
Safety beam equipment
returned to normal
funconing status.
Alarm output
returns to
standby.
Gate closed.
O
0
20 sec.
On/o...
Built in buzzer sounding is
oponal.
On
O
Advanced features
Gate kept open too long alarm.
In a cases where the user would like to be noed of the gate being kept open for longer than a predetermined me period, the gate jammed open
alarm can be setup. The alarm condion will reset to o when the gate is closed again.
Acon Response
Gate prevented from
closing.
Alarm output
remains in
standby status.
Aer programmed gate
jammed open me.
Alarm output
acvates.
Gate returns to full
closed posion.
Alarm output
returns to
standby.
O
0
20 sec.
On/o...
Built in buzzer sounding is
oponal.
On
O

Related product manuals