E.T. Systems Drive 600 - Page 24

24
WARRANTY:
1. All goods manufactured by ET NICE (Pty) Ltd carry a 12 month factory warranty from date of invoice.
2. All goods are warranted to be free of faulty components and manufacturing defects.
3. Faulty goods will be repaired or replaced at the sole discreon of ET NICE (Pty) Ltd free of charge.
4. This warranty is subject to the goods being returned to the premises of ET NICE (Pty) Ltd.
5. The carriage of goods is for the customer’s account.
6. This warranty is only valid if the correct installaon and applicaon of goods, as laid out in the applicable documentaon accompanying
said goods, is adhered to.
7. All warranty claims must be accompanied by the original invoice.
8. All claims made by the end user must be directed to their respecve service provider/installer.
The following condions will disqualify this product from the warranty as laid out above. These condions are non- negoable.
1. Any unauthorized non-manufacturer modicaons to the product or components thereof.
2. Any modicaon to the installaon methods described in the installaon instrucons.
3. Any applicaon or use of the product other than the intended use and applicaon described in the product documentaon.
The following items are not included in the warranty or they carry a special warranty condion of their own.
1. The baery (Limited 6 month warranty)
2. The motor brushes.
3. Damage resultant of wind and other climac inuences such as lightning strikes.
4. Damage due to high voltage surges on the household mains or short circuing of the gates to the electric fencing.
5. Damage due to infestaon i.e. Ants nesng…
6. Water damage. It is the responsibility of the installer to ensure the product is installed in a locaon that is protected from water ingress.
The ingress protecon rang is specied in the accompanying documentaon. Housings that require that cable entries are made by the
installer do not carry an ex-factory ingress protecon rang as it is the responsibility of the installer to seal the cable entry points aer
installaon of the cabling.
Drive 500 Drive 600
For further product documentaon, such as the sales
brochure, visit our webpage by scanning either of the QR
codes here: