E-XTEQ DS One - Using Vehicle VIN for Diagnostic Identification

26/40
E-XTEQ DS ONE User Manual / Ref. MAN_DSOne_STL_EN_V1.3
Diagnostic PDI 4/9
BATTERY SELECTION ////////
Using VIN Code
Select .
Fill in the VIN either by scanning it or
manually. If there is no QR code on the
vehicle, one can be created an scanned
using an internet QR code generator.
Select
to validate.
Depending on the recognition of the
VIN, the model and/or nish and battery
of the vehicle must be selected.
If more than ten vehicles are found with the VIN, the tool will respond as if no
vehicle was found. Manual selection or bypass will be necessary.
If the VIN is not recognized, you will
have to select the battery characteristics.
Select
to do so according to the
database.
It will require to select the make, then
the model, then the nish and the
battery of the vehicle and whether it is
the main or auxiliary battery.
Otherwise select
to directly enter
the battery characteristics.
It will require to select the chemistry.
Table of Contents
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Information internal battery
Getting Started
Safety Reminders
Appearance and Dimensions
Presentation
Job Storage
Accessories
Best Practices
Positioning of the clamps
Connector longevity
Hybrid vehicles
Initial Setup
Power Cable Connection and Power On
Battery Cable Clamps Connection
Optimus
- Optimus installation
- Using Optimus
Update
Garage code (RRDI)
Settings
Preferences
WI-FI Connection
Other settings
Diagnostic PDI and REPAIR
Battery selection
- Using BK code
- Using VIN
Start Diagnostic
Other diagnostics
Results
Results storage
Support Information
Warranty
Technical specications