E-XTEQ DS One - Best Practices for DS One Usage; Correct Clamp Positioning for Accurate Measurements

9/40
E-XTEQ DS ONE User Manual / Ref. MAN_DSOne_STL_EN_V1.3
Best Practices 1/2
Table of Contents
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Information internal battery
Getting Started
Safety Reminders
Appearance and Dimensions
Presentation
Job Storage
Accessories
Best Practices
Positioning of the clamps
Connector longevity
Hybrid vehicles
Initial Setup
Power Cable Connection and Power On
Battery Cable Clamps Connection
Optimus
- Optimus installation
- Using Optimus
Update
Garage code (RRDI)
Settings
Preferences
WI-FI Connection
Other settings
Diagnostic PDI and REPAIR
Battery selection
- Using BK code
- Using VIN
Start Diagnostic
Other diagnostics
Results
Results storage
Support Information
Warranty
Technical specications
POSITIONING OF THE CLAMPS ////////
To enable a reliable measurement be careful when positioning the clamps to ensure
that the four jaws are in contact with the battery plots.
Be advised that if it is not the case all measurement will be distorted.
Jaws of both clamps are not in contact.
All jaws are in contact.