E-XTEQ DS One - Usage Precautions and Warnings; Product Disassembly and Damage Policy; Product Cleaning Guidelines; Internal Battery Information and Safety

5/40
E-XTEQ DS ONE User Manual / Ref. MAN_DSOne_STL_EN_V1.3
Safety Guidelines 2/2
USAGE PRECAUTIONS ////////
Do not use extension cords as there is a risk of re and electrical shortage. If usage is
necessary, check that the extension cord has the following:
1. Identical plug, cable size and the same electrical wiring as the DS One.
2. Make sure the equipment is securely connected before use.
When unplugging the cord from the outlet, hold the plug itself to avoid damaging
the plug or power cord. Pulling the cord may cause the cable plug to break. Replace
power cord immediately if damaged.
It is recommended to check your product annually. Please contact the manufacturer
for a complete check and periodic calibration.
DISASSEMBLY/DAMAGE/REMOVAL ////////
Do not disassemble the product or damage or remove the stickers or labels on the
product. If the product’s case has been disassembled or damaged by the user, all
warranties will be void. Always contact a designated E-XTEQ Service Center for
repairs.
Do not insert metallic objects into the unit to avoid electric shock, re, short circuit,
possible leaking of harmful substances and personal injuries. Do not store the
product in a wet or humid place. Always store the product in a dry place.
CLEANING THE PRODUCT ////////
It is recommended that you clean the product by wiping it gently using a soft cloth.
Do not use water, chemical substances or detergents. They may cause discoloration
or corrosion to the product’s exterior and may cause a re or electric shock.
INFORMATION INTERNAL BATTERY ////////
Product Name: Lithium-Ion Polymer Rechargeable Battery
E-XTEQ reference: C6250008a
Model Number: HCP104060ZC
Cell Type: HCP104060
Voltage/Capacity: 3,7V / 3000mAh
Recommended use: Charge with specic charger according to product specication.
Charge with CC/CV model.
When not using cell for long periods of time, remove it from the equipment and
store in a place with low humidity and low temperature. Batteries have life cycles. If
cell powers equipment a much shorter time than usual, please replace the cell with a
new one. Battery would be over-discharged by its self-discharge characteristics if the
battery is not used for a long time. In order to prevent over-discharging, the battery
shall be charged periodically to maintain between 3.7V and 3.99V/cell.
Restriction on use: Reverse charging is prohibited, for it will deteriorate the cell
performance and lead to safety issues such as heat and leakage. Stop using the cell
if abnormal heat, odor, discoloration, deformation or abnormal condition is detected
during use, charge, or storage. Do not put battery into a microwave oven, dryer, or
high-pressure container.
It is prohibited to use the battery close to re or in areas where temperatures are
above 45°C. Also, do not charge / discharge in such conditions.
Table of Contents
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Information internal battery
Getting Started
Safety Reminders
Appearance and Dimensions
Presentation
Job Storage
Accessories
Best Practices
Positioning of the clamps
Connector longevity
Hybrid vehicles
Initial Setup
Power Cable Connection and Power On
Battery Cable Clamps Connection
Optimus
- Optimus installation
- Using Optimus
Update
Garage code (RRDI)
Settings
Preferences
WI-FI Connection
Other settings
Diagnostic PDI and REPAIR
Battery selection
- Using BK code
- Using VIN
Start Diagnostic
Other diagnostics
Results
Results storage
Support Information
Warranty
Technical specications