Installation, Operation and Parts Manual
EE-6435B .WF
4.2 Installation attentions
4.2.1 Joints of oil hose and wiring must be firmly connected in order to avoid leakage of oil hose and looseness of electrical wires.
4.2.2 All bolts should be firmly screwed up.
4.2.3 Do not place any vehicle on the lift in the case of trial running.
4.3 General installation steps
Step 1: Fix the installation layout.
Once the installation site is determined, mark first the four standing points of the four posts by a tape measure and chalk. Ensure two diagonal
lines are of the same length.
Step 2: Remove the packing materials.
1. Place some wooden battens (thickness of which should be more than 80mm) on the ground (other dependable devices may also applicable)
and then use forklift to have the packing rack removed on to the battens so as to make its base is of some clearance from the ground.
2. Have the platforms of the lift suspended by the forklift and then screw off the upside bolt and remove the first platform on to the wooden
battens initially prepared.
3. Screw off the downside bolt and take away the packing racks on both sides.
4. Remove the shock absorption plastic film with a knife.
Attention: Avoid scratching the painting surface and hoses.
To Next Page
