Eaglemaster E8 - Programming of codes for new transmitters; Programming of new transmitters

Programming of codes for new transmitters
Important
Please notice that during the programming of a new transmitter into the system memory all
previous programmed codes of the transmitters will be erased so in case of programming
for additional transmitters the available transmitters shall be programmed again.
The system supports in memory up to four codes of remotes irrespective of the fact if the
codes of four different remotes or the same code four times is recorded into the system.
Programming of new transmitters.
Important
Please notice that each following operation shall be done within 10 sec after the previous
operation. If the 10 second period is over the system will automatically exit the
programming mode and two long chirps will acknowledge the exit. If the ignition is turned off
during programming the system will immediately exit the programming mode and two long
chirps will acknowledge the exit.
1. Disarm the system .
2. Turn the ignition from on to off.
3. Within 10 sec after switching off the ignition press and hold the Valet button over 3 sec ,
the LED starts flashing , release the Valet button.
4. Press and hold the Valet button, you will hear the siren start chirping (from 1~3 chirp),
while give 2 chirp sound, immediately release the Valet button.
5. The LED will start flashing to acknowledging that the system is ready for programming of
new transmitters.
6. Press any button of the first transmitter, you will hear 1-short chirp acknowledging that
the first transmitter has been programmed
Press any button of the second transmitter, you will hear 2-short chirp acknowledging
that the second transmitter has been programmed.
Repeat the operation 3 for other transmitters.
7. To exit the transmitter programming mode, Turn on the ignition and you will hear two long
siren chirps.