Functions Step Condition
Remote button lock (on/off)
Vibrate mode on/off
Clock time adjust mode
Clock time engine start
Battery conserve mode
Press over 2sec. until 1 beep given.
Press over 2sec. until 1 beep given.
Press over 2sec. until 1 beep given.
Press over 4sec. until 2 beep given.
Press over 2sec. until 1 beep given.
Remote battery discharge/replacement
If the battery becomes exhausted, the remote will emit extra long beep, While press any
button on the remote, few seconds later the indicator will flashing for identify.
The battery discharge is displayed on the LCD screen as the icon with the status indicator .
Also you can pay your attention that the effective distance for the transmitter is being
reduced.
To replace the batteries of 2-way remote
- Bend the top part of the cover a bit, move it up and remove,
- Remove the discharged battery,
- Place the new battery (AAA) observing polarity,
- Carefully place the cover back.
To replace the batteries of 1-way remote
- Loose the screws on the back side of the transmitter housing and separate two halves of
the transmitter housing,
- Remove the discharged battery,
- Place the new battery 12V 23A observing polarity,
- Carefully place the cover back (please do not damage the LED and switchers on the
Circuit board);
tighten the screws on the back side of the transmitter housing.
To Next Page
Loading...
