Eaglemaster E8 - Clock time engine start; To set clock time engine start the vehicle; Arm with engine run mode; To perform Arm with engine run mode

Exit the Clock time engine start mode:
1. press the button over 2sec. then press again the button over 2sec.
2 beep sound will be heard and clock icon flashing.
2. Press button to disable clock time. 2 beep will be heard and exit the mode.
- Clock time engine start: Press the button over 2sec. for twice time.
This feature will engine start by pre-setting clock time. This makes it possible to warm up
the engine (Table-3 of NO.1 ), as well as the system is in Safe status.
To set clock time engine start the vehicle:
1. press the button over 2sec. then press again the button over 2sec.
2 beep sound will be heard and clock icon flashing :
2. Press button to select Hour & Min adjust setting. Icon flashing to indicate.
3. Press button to turn up the numbers. Press button to turn down the numbers.
The button may be held down to scroll faster.
4. Press button to enable clock time. 1 beep will be heard and exit the mode.
Press button to disable clock time. 2 beep will be heard and exit the mode.
Note: The remote will revert to normal operation from the set mode when 10-seconds has
elapsed without a button entry.
2-way LCD display :
-Arm with engine run mode:
This feature
The engine running time can be programmed (2/5/10/untimited time (Table-1 No.9).
owever the engine will keep running.
(Table-1 of No.8 ON status)
allows the vehicle to remain running after the key has been removed from the
ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running and the climate controls on.
To perform Arm with engine run mode:
1. Before turning off the engine, make sure the system is in Safe status as: ( Hood switch
closed, Hand brake on, Park switch gear on.)
2. Press the button over 2sec. The status LED will start flashing twice per second and
the parking light will active as programme (Table-3 of NO.5)
3. Turn the ignition key to the OFF position. (The engine will stay running.)
4. Press the button , to arm the system , h
The engine will run until the pre-programmed time elapses or a shut-down input is
received. (See the Remote Start section for a complete list of shut-down inputs.)
Note: This feature will not work if the brake pedal is being pressed.
Icon flashing
indicator