. Control of the CH-1 (Remote latched) - Press the button over 2sec.
Simply press and hold button 4 over 2 seconds, the channel will constant output .
To exit by press and hold button 4 over 2 seconds, the channel will deactivated.
. Control of the CH-1 (programming time output with sensor off /on) -
Press the button over 2sec.
Simply press and hold button 4 over 2 seconds, the channel will constant output
The sensor zones can be turn off or on status , during the channel activated, check Table-2
of NO.5.
for the pre-
programmed period of time or until press the button 4 over 2 seconds.
Additional service functions to control the system
- Remote controlled additional channel (CH-1)
The system has the channel CH-1 to control various additional devices connected to the
system. The channel can be used
for : (Table-2 of NO.5)
- Remote trunk open .
- Remote Latched.
- Remote control of with the programme timer (1~120sec.) and sensor zones off.
- Remote control of with the programme timer (1~120sec.) and sensor zones on.
This channel "Gray wire" is a negative pulsed output.
- Program controlled additional channel (CH-2)
The system has the channel CH-2 to control various additional devices connected to the
system. The channel can
be used for : (Table-2 of NO.6)
- Disarming pulsed output for 30 seconds .
- Remote Latched.
- Remote control of with the programme timer (1~120sec.) and sensor zones off.
- Remote control of with the programme timer (1~120sec.) and sensor zones on.
This channel "White/black wire" is a negative pulsed output.
. Control of the CH-1 (Trunk open) - Press the button over 2sec.
Simply press and hold button 4 over 2 seconds, the channel will output for 1 second pulse ,
to open the trunk. When armed if remote trunk open or close, the 2-way remote will give one
beep sound and display icon as under:
Note. If the CH1 channel output is enable when the system was in the armed mode the
system will simultaneously turn off the shock sensor and the trunk trigger. As soon as the
trunk is closed the system will automatically re-arm the circuit and turn the shock sensor on.
Note: (1) Ignition ON does not allow to remote trunk open.
(2) Armed, if trunk keep opened over 1 minutes, the 2-way remote will give pre-warn
beep sound.
2-way LCD display :
To Next Page
Loading...
