Eaglemaster E8 - Program controlled additional channel (CH-3); Control of the CH-3 (Arming outputfor 30 sec.); Control of the CH-3 (Remote latched)

. Control of the CH-2 (Disarming output for 30sec.)
If programmed , the channel will constant output 30sec. when disarming. This feature
for the car with dome-light supervision.
. Control of the CH-2 (Remote latched) - Press the button over 2sec.
Simply press and hold button 1+4 over 2 seconds, the channel will constant output .
To exit by press and hold button 1+4 over 2 seconds, the channel will deactivated.
. Control of the CH-2 (programming time output with sensor off /on) -
Press the button over 2sec.
Simply press and hold button 1+4 over 2 seconds, the channel will constant output
The sensor zones can be turn off or on status , during the channel activated, check Table-2
of NO.6.
for the
pre-programmed period of time or until press the button 1+4 over 2 seconds.
. Control of the CH-3 (Arming output for 30sec.)
If programmed , the channel will constant output 30sec. when arming. This feature for
the car with window closing after arming.
. Control of the CH-3 (Remote latched) - Press the button over 2sec.
Simply press and hold button 2+4 over 2 seconds, the channel will constant output .
To exit by press and hold button 2+4 over 2 seconds, the channel will deactivated.
. Control of the CH-2 (programming time output with sensor off /on) -
Press the button over 2sec.
Simply press and hold button 2+4 over 2 seconds, the channel will constant output
The sensor zones can be turn off or on status , during the channel activated, check Table-2
of NO.7.
for the
pre-programmed period of time or until press the button 2+4 over 2 seconds.
- Program controlled additional channel (CH-3)
The system has the channel CH-3 to control various additional devices connected to the
system. The channel can be
used for : (Table-2 of NO.7)
- Arming pulsed output for 30 seconds .
- Remote Latched.
- Remote control of with the programme timer (1~120sec.) and sensor zones off.
- Remote control of with the programme timer (1~120sec.) and sensor zones on.
This channel "Gray/black wire" is a negative pulsed output.
- Remotecontrolled additional channel (CH-4)
The system has the channel CH-4 to control various additional devices connected to the
system. The channel can
be used for : (Table-2 of NO.8)
- 2nd stage door unlock .
- Remote Latched.
- Remote control of with the programme timer (1~120sec.) and sensor zones off.
- Remote control of with the programme timer (1~120sec.) and sensor zones on.
This channel "Orang/black wire" is a negative pulsed output.