Eaglemaster E8 - Changing of the PIN code to turn off the system

- Additional (alarm) call if alarm call button located on the antenna
module of the transceiver is pressed
- The system has an additional channel to transfer the signal to call for/notify the owner of
the two-way communication remote. The call can be made by the second person being in
the car and enabling the call button on the module of the antenna pager. The call is
formed by pressing the call button .
- The two-way communication remote will start issuing frequent beeps few seconds.
Receiver-
transmitter unit
# BASE-2
Transceiver
Call button
LED
indicator
LED
indicator
2-way LCD display :
To indicate that the call
button activated.
Changing of the PIN code to turn off the system
This system provide 2 digit PIN code, each digit code can be programme from 1 to 9 , and
manufacturer code is ( 2.5).
To program your new PIN code as follows:
1. Disarm the system .
2. Turn the ignition from on to off.
3. Within 10 sec after switching off the ignition press and hold the Valet button over 3 sec ,
the LED starts flashing , release the Valet button.
4. Press and hold the Valet button, you will hear siren chirp (from 1 to 3 chirp sound),
while give 3 chirp sound, immediately release the Valet button.
You will automatically at the PIN code setting mode. Siren will give 1 long chirp sound.
5. Enter the first digit of the code with the Valet button (the number of pressing the Valet
button corresponds to one digit of the code);
Press remote button 1 once to confirm the first code, by given 1 chirp sound.
6. Enter the second digit of the code with the Valet button (the number of pressing the
Valet button corresponds to the second digit of the code);
Press remote button 1 once to confirm the second code, by given 2 chirp sound.